Page 1 of 1

The Wilderness Protocol

Posted: Wed Mar 06, 2024 12:31 pm
by OSCAR-03
The Wilderness Protocol is a suggestion that those outside of repeater range should monitor standard simplex channels at specific times in case others have Emergency or priority calls. The primary frequency is 146.52 MHz with 52.525, 223.5, 446.0 and 1294.5 MHz serving as secondary frequencies. This system was conceived to facilitate communications between hams that were hiking or backpacking in uninhabited areas, outside repeater range. However, the Wilderness Protocol should not be viewed as something just for hikers. It can (and should) be used by everyone anywhere repeater coverage is unavailable. The protocol only becomes effective when many people use it.The Wilderness Protocol recommends that those stations able to do so should monitor the primary (and secondary, if possible) frequency every three hours starting at:
  • 7 AM, local time, for 5 minutes…
  • 10 AM
  • 1 PM
  • 4 PM
  • 7 PM
  • 10 PM
Additionally, those stations that have sufficient power resources should monitor for 5 minutes starting at the top of every hour, or even continuously.NOTE*** Placing 146.52 MHz , 52.525, 223.5, 446.0 and 1294.5 MHz in your Scanner would help.Priority transmissions should begin with the LiTZ signal. ( LONG TONE ZERO )
CQ-like calls (to see who is out there) should not take place until four minutes after the hour.